Lay the blanket on top of the foam board and press down, working from one side to the next. Allow to set for 15-30 seconds.at this point the adhesive is tacky, but you can still adjust what you stick to it. Spray 3M Super 77 generously on the op of the foam board.
This is to prevent hot spots, or so the other Instructables tell me :) Open the emergency blanket and crinkle it up repeated to remove the creases and create lots of small wrinkles. The spray adhesive is strong and difficult to get off surfaces without thinner.which would likely take the finish right off of any dining or kitchen table. Be sure to cover your work surface with old cardboard or other such disposable material. * Gaffer's tape is stronger than duct tape, more easily adjusted, and makes for a better hinge in that folding and re-folding it won't wear out it or it's adhesive.įollow me on Instagram - the soft white reflector used in the previous step and lay it flat so the tape hinge is facing down. What makes these unique compared to others is their size (they are quite large - 40" x 60"), and the use of gaffer's tape to make a sturdy hinge that requires tape on only one side.
Made from materials already around the house.My requirements were simple, they had to be: Inspired by some of the other Instructables on DIY photo reflectors, I decided to make my own. That didn't leave any room in my budget for the fancy lighting reflectors my book recommended. I recently invested in three things to help improve my Instructables:
0 kommentar(er)
